| Titre : | Influence of (Al, Co) co-doping concentration on the Physical Properties of ZnO Thin Films Prepared via Pneumatic Spray Method |
| Auteurs : | Meriem ABBAS, Auteur ; Nadjette Hamani, Directeur de thèse |
| Type de document : | Mémoire magistere |
| Editeur : | Biskra [Algérie] : Faculté des Sciences Exactes et des Sciences de la Nature et de la Vie, Université Mohamed Khider, 2026 |
| Format : | 1 vol.(P87 / ill.couv.ill.en coul / 24cm |
| Langues: | Français |
| Mots-clés: | ZnO, thin film, Aluminium doping, cobalt doping, co-doping. |
| Résumé : |
The objective of this work is to prepare and characterize zinc oxide (ZnO) thin films doped with aluminum (AZO) and co-doped with aluminum and cobalt (CAZO), with different cobalt concentrations (1%, 3%, and 5%), prepared by the pneumatic spray pyrolysis technique. The effect of doping on the structural, optical, morphological, and electrical properties of the prepared films was studied. To analyze these properties, several characterization techniques were used, including X-ray diffraction (XRD) to study the crystal structure, UV–Visible spectroscopy to study the optical behavior, scanning electron microscopy (SEM) to study the surface morphology and microstructure of the films, and the four-point probe technique to measure the electrical resistivity.The structural analysis shows that all films have a hexagonal wurtzite structure withpreferred orientations of (002) and (101). UV–Visible results show high optical transmittance(60.86%–87.78%), with a band gap ranging from (3.256 - 3.289) eV, and Urbach energy between (0.08- 0.28) eV. Electrical measurements indicate that the resistivity ranges between (30.95× 1- 71.25× 102) Ω·cm. SEM analysis shows that adding cobalt changes the film morphology, reduces grain size, and decreases crystallinity. |
| Sommaire : |
ACKNOWLEDGEMENT DEDICATION CONTENTS List of Figures List of Tables General Introduction...................................................................................1 CHAPTER I: OVERVIEW OF ZINC OXIDE. I.1Transparent conductive oxide (TCO) .............................................................4 I.1.1 Criteria for choosing TCO...................................................................5 I.2 Zinc Oxide (ZnO) .............................................................................6 I.2.1 Definition .....................................................................................6 I.2.2 Properties of ZnO ............................................................................6 I.2.2.a Structural Properties........................................................................6 I.2.2.b Electrical properties ........................................................................7 I.2.2.c Optical properties et luminescence ......................................................8 I.2.3 Doping of ZnO..................................................................................8 I.2.3.1 n-type doping ...............................................................................8 I.2.3.2 p-type doping................................................................................9 I.2.4 Co-doping ZnO................................................................................9 I.2.5Application of ZnO...........................................................................10 I.2.6 Literature review of ZnO thin film.........................................................12 References............................................................................................17 CHAPTER II: THIN FILMS DEPOSITION TECHNIQUES AND CHARACTERIZATION METHODS. II.1 Definition of a thin film........................................................................21 II.1.1 Thin film growth mechanisms................................................................21 II.1.2 Basic growth modes...........................................................................22 II.2 Deposition methods.............................................................................23 II.3 Criteria for selection of a deposition technique.............................................24 II.4 Choosing the ZnO deposition process.........................................................24 II.5 Spray pyrolysis .....................................................................................25 II.5.1 Principle ..........................................................................................25 II.6 Characterization Methods.....................................................................27 II.6.1 Thickness Measurements .....................................................................27 II.6.2 Structural Characterization ...................................................................... .28 II.6.2.1 X-Ray Diffraction..............................................................................28 II.6.2.2 Determination of structural properties.........................................................29 II.6.2.2.a attice parameters..............................................................................29 II.6.2.2.b Measurement of crystallite size, the dislocation density and the strain...............30 II.6.2.2.c Determination of Stresses .................................... ..............................31 II.6.3 Optical Characterization.....................................................................32 II.6.3.1 UV-visible spectroscopy ..................................................................32 II.6.3.2 Optical Band Gap..............................................................................34 II.6.3.3 Urbach Energy.................................................................................35 II.6.4 Morphological Characterization of Thin Films................................................36 II.6.4.1 Scanning Electron Microscope (SEM)......................................................36 II.6.4.2 Energy dispersive X-ray spectroscopy (EDX).............................................37 II.6.5 Electrical Characterization ..................................................................38 II.6.5.1 Four-point-probe Method.......................................................................38 II.6.5.2 Electrical Resistivity Measurement ...........................................................39 References..................................................................................................40 CHAPTER III: EXPERIMENTAL RESULTS AND DISCUSSION III.1 Experimental method.............................................................................47 III.1.1 Pneumatic spray pyrolysis technique...........................................................47 III.1.2 Preparation of subsates and precursor solutions..............................................48 III.1.2.1 Preparation of substrates.....................................................................48 III.1.2.2 Preparation of solutions........................................................................49 III.1.2.3 Deposition of thin films........................................................................51 III.2 Results and discussion...........................................................................52 III.2.1 Growth rate .......................................................................................52 III.2.2 Structural properties.............................................................................53 III.2.2.1 XRD Diffraction ...........................................................................53 III.2.2.2 Crystallite size.................................................................................56 III.2.2.3 Dislocation density, strain and stress.........................................................57 III.2.2.4 lattice parameters..............................................................................59 III.2.3 Morphological properties........................................................................60 III.2.4 Optical properties ..............................................................................61 III.2.4.1 Transmittance spectra ........................................................................61 III.2.4.2 Optical band gap and Urbach energy......................................................62 III.2.5 Electrical properties...............................................................................64 References..................................................................................................66 General Conclusion......................................................................................70 |
Disponibilité (1)
| Cote | Support | Localisation | Statut |
|---|---|---|---|
| MPHY/690 | Mémoire master | bibliothèque sciences exactes | Consultable |




