| Titre : | Effect of Film Thickness on the Properties of Fe-doped ZnO Thin Films Deposited by the Spray Pyrolysis Method |
| Auteurs : | Ikram TIBERMACINE ; Ouanassa Haif Khaif, Directeur de thèse |
| Type de document : | Mémoire magistere |
| Editeur : | Biskra [Algérie] : Faculté des Sciences Exactes et des Sciences de la Nature et de la Vie, Université Mohamed Khider, 2026 |
| Format : | 1 vol.(P74) / ill.couv.ill.en coul / 24cm |
| Langues: | Anglais |
| Mots-clés: | Fe-doped ZnO ; Thin films ; Spray pyrolysis ; Film thickness ; Urbach energy. |
| Résumé : |
In this research, 5% iron-doped zinc oxide thin films were prepared on glass substrates at 400 °C using the spray pyrolysis technique. The study systematically evaluated the effect of varying film thickness (153, 193, 321, and 330 nm) on the structural, optical, and electrical properties. X-ray diffraction confirmed that all films exhibit a polycrystalline hexagonal wurtzite structure. Optical analysis revealed a decrease in transmittance with increasing thickness. The optical bandgap energy exhibited an oscillatory behavior, initially increasing from 3.27 to 3.30 eV, which coincided with a decrease in Urbach energy from 0.10 to 0.09 eV. For the thickest films, the bandgap reduced to 3.26 eV due to the accumulation of localized states. Electrically, the resistivity displayed a similar oscillatory trend: it was initially low, spiked remarkably for the 193 nm film, and then dropped significantly in the thicker samples, perfectly synchronized with the sharp increase in Urbach energy. |
| Sommaire : |
Acknowledgements.............................................................................................................. I Dedication.............................................................................................................. II Table of contents..................................................................................................... III List of Figures............................................................................................ VII List of tables ............................................................................................ IX General introduction........................................................................................ 1 References.......................................................................................... 4 Chapter I: Generalities on Transparent Conducting Oxides I.1. Introduction......................................................................... 05 I.2. Transparent conductive oxides.......................................................... 05 I.3. Properties of Transparent Conducting Oxides (TCOs).......................................... 06 I.3.1. Electrical properties.................................................................................... 06 I.3.1.1. Energy Band gap (Eg)................................................................................ 07 I.3.1.2. Electrical conductivity (σ).............................................................. 07 I.3.1.3. Mobility (μ)..................................................................... 08 I.3.2. Optical Properties............................................................. 08 I.3.2. 1 . Transparency (T),Absorption (A), and Reflectivity (R)......................................................... 09 I.3.2.2. Refractive index (n)......................................................................... 11 I.4. Transparent Conducting Oxides: Intrinsic and Doped (TCOs)..................................................... 11 I.4.1. Intrinsic Transparent Conducting Oxides....................................................... 11 I.4.2. Doped (Extrinsic) Transparent Conducting Oxides................................................................ 12 I.4.2.1. n-type Doping.................................................................... 12 I.4.2.2. p-type Doping....................................................................... 13 I.5. Criteria for Selecting Transparent Conducting Oxides (TCOs).................................................... 14 I.6. Zinc Oxide (ZnO)............................................................ 15 I.6.1. Definition.......................................................... 15 I. 6.2 Selection of Zinc Oxide (ZnO).......................................................... 16 I.6.3. Properties of zinc oxide (ZnO) .................................................. 17 I.6.3.1. Structural properties....................................................... 17 I.6.3.2. Electrical Properties...................................................... 19 I.6.3.3. Optical Properties........................................................... 20 I.6.4. Selected Applications of Zinc Oxide (ZnO)............................................................................ 21 I.7. Iron-Doped Zinc Oxide (Fe-Doped Zn)...................................................................... 24 I.7.1. Iron (Fe).................................................. 24 I.7.2. Crystal Structure of Iron............................................. 24 I.7.3. Physical and Chemical Properties of Iron ........................................ 25 I.7.4. Reference Study............................................................................................. 25 References.......................................................................................................... 27 Chapter II: Thin Films: Fundamentals, Deposition Methods, and Characterization I.1. Introduction................................................................................................... 31 II.2. Definition of Thin Films.................................................................................... 31 II.3. Mechanisms and Media for Thin Film Deposition...................................................... 32 II.4. Stages and Mechanisms of Thin Film Growth............................................................. 32 II.4.1. Nucleation.................................................................................................... 33 II.4.2. Coalescence............................................................................................... 33 II.4.3. Growth...................................................................................................... 34 II.5. Classification of Thin Film Growth Modes.............................................................. 35 II.5.1. Island Growth (Volmer–Weber Mode) ............................................................... 35 II.5.2. Layer-by-Layer Growth (Frank–van der Merwe Mode) ............................................. 35 II.5.3. Mixed Growth (Stranski-Krastanov Mode) ........................................................... 36 II.6. Overview of Deposition Techniques......................................................................... 36 II.7. Spray Pyrolysis Technique........................................................................................ 37 II.7.1. Historical Background.................................................................................... 38 II.7.2. Components of the Chemical Spray Pyrolysis System............................................... 38 II.7.3. Mechanism of Thin Film Formation via Chemical Spray Pyrolysis................................ 40 II.7.4. Evaluation of the Spray Pyrolysis Technique................................................................ 41 II.8. Characterization methods..................................................................................... 42 II.8.1 Structural characterization.............................................................................. 42 II.8.1.1 X-Ray Diffraction (XRD) .............................................................................. 42 Lattice parameters....................................................................................... 45 The crystallite size....................................................................................... 45 Dislocation Density (δ) and Microstrain (ε) ......................................................... 46 II.6.2. Optical characterization...................................................................................... 47 II.6.2.1. Ultraviolet-Visible Spectroscopy (UV-Vis)......................................................... 47 Thickness of the thin film.................................................................................. 48 Transmittance and absorption Coefficient (α) .......................................................... 48 Energy band gap.......................................................................................... 49 Urbach Energy (EU) ..................................................................................... 50 II.6.3. Electrical characterization................................................................................ 51 II.6.3.1. 4-Point Probe Method..................................................................................... 51 II.6.3.2. Sheet Resistance (Rs), the resistivity (ρ), and the conductivity (σ) ............................. 52 References.................................................................................................................. 53 Chapter III: Results and discussion III.1. Introduction................................................................................................ 56 III.2. Choosing Glass as a Substrate............................................................................ 56 III.3. Substrate Cleaning.......................................................................................... 56 III.4. Properties of the chemicals used........................................................................... 57 III.5. Solution Preparation........................................................................................ 58 III.6. Thin Film Deposition....................................................................................... 59 III.7. Thin Film Analysis....................................................................................... 60 III.7.1. Structural properties and deposition rate .......................................................................... 60 III.7.1.1 Deposition rate and thickness ......................................................................... 60 III.7.1.2. X-ray diffraction analysis ........................................................................... 61 Lattice parameters......................................................................................... 63 Crystallite size and structural defects.................................................................. 63 III.7.2. Optical properties.......................................................................................... 65 UV-Vis transmittance analysis............................................................................. 65 Band gap energy and Urbach energy................................................................... 66 III.7.3. Electrical properties....................................................................................... 68 Electrical resistivity.......................................................................................... 69 Figure of Merit (FOM)................................................................................... 70 References.............................................................................................................. 72 General Conclusion ............................................................................................... 74 |
Disponibilité (1)
| Cote | Support | Localisation | Statut |
|---|---|---|---|
| MPHY/688 | Mémoire master | bibliothèque sciences exactes | Consultable |




